Tricer-LD Camera Clip

Built for outdoor photographers, travel shooters, and working pros who need a camera clip designed for backpacks with narrow webbing straps. The TRICER LD Camera Clip connects your camera to the narrow nylon straps (up to 1")commonly found running across the shoulder straps of outdoor, adventure, and technical packs — the same straps where wider clip systems struggle to fit or hold securely.

The ambidextrous dual button release means easy and accessible quick disconnection from the clip, with no accidental disconnections. The Slide-lock safety means clear communicated feedback for a secure connection every time. The backpack strap fit (for up to 1.14” wide) is coated with anti-slip and anti-abrasion rubber.  The TRICER LD is the most secure, accessible, and reliable camera carry solution available for outdoor packs with narrow front webbing.

TRICER LD Installation

WARNING: DO NOT USE WITHOUT FOLLOWING THE INSTALLATION PROCESS BELOW AND INSTALLING THE LD TO 1" STRAP. 

• Step 1 -Using the included Allen key, loosen and remove the four set screws from the back of the bottom plate. Separate the top and bottom plates.
• Step 2 -Position the bottom plate underneath the 1-inch webbing on your backpack shoulder strap at your desired mounting height.
• Step 3 - Place the top plate over the 1-inch webbing and align it with the bottom plate. Make sure all four set screw holes are properly aligned.
• Step 4 - Reinstall the four set screws using the included Allen key, then tighten them evenly until the mount is securely attached.
• Step 5 - Attach the camera plate to the bottom of your camera by threading the mounting screw into the camera's tripod socket and tightening it securely.
• Step 6 - Slide the camera plate into the receiver on the top plate until it locks into place. To remove the camera, press either of the ambidextrous release buttons and slide the camera plate out.